Schroth Racing QuickFit And QuickFit Pro BMW E82 / E92 / E92 LCI - Manual (Page 11)

11
• Any changes made to the belt will automatically void the
warranty.
Never use any restraint system that does not function
properly. If questions arise, immediately contact your
importer or the manufacturer!
We do not recommend to disassemble the length adjuster
during installation process. Even to run the harness belt
through the openings at racing seats disassembling is
not necessary.
If for any reason the length adjuster is disassembled, strictly
follow the procedure step by step as described below to re-
assemble the adjuster.
2 Accident
A safety belt which was in use during an accident has
been weakened and is unfit for further use and must be
replaced! One indication that the belt was exposed to
excess strain and therefore requires replacement is when
the stitches of the asm-system are ripped open and are
protruding from underneath the asm-plastic cover.
A restitched asm seam is dangerous.
The asm energy conversion device may not be restitched
under any circumstances.
After an accident, in addition to replacing seat belt which were
in use, also be sure to ask your car dealer for carefully check
all seatbelt attachment points for deformation or cracks.
Always make sure that the guidelines of the car manufacturer
are followed if a repair is necessary.
3 Re-assembling the length adjuster 4 Cleaning
To clean the belt, use soap and warm water. Do not use any
solvents! Do not dry the belt in the sun or near a radiator.
Improper cleaning or drying of the harness belts can
weaken them, reduce their effectiveness and can result in
serious personal injury or death.
5
Installation Accessories
Color key:
black=0, blue=1, red=2, yellow=3, purple=5, green=8
The X in PINs must be substituted by the color key of the color you want to order!
Shoulder belt pads, pair of
black with yellow flock printing 00109
Shoulder belt pads, pair of blue with black flock printing 01109
red, yellow, purple, green with black flock printing 0X109
Shoulder belt pads, pair of black with gray flock printing 09109
Shoulder belt pads, pair of silver-gray w. black flock printing 09209
Shoulder belt pads, pair of black with black flock printing 09309
Adjusting grips for length adjuster, 4 pcs./package 00092
Figure A:
Fold the strap to a loop and insert it
upwards throughout the metal frame and
turn the loop as indicated.
Note:
The strap part protruding from the
adjuster for further adjustment [1] must
be located above the stress taking strap
[2].
Figure B:
Position the plastic cover on top of the
loop and insert the metal retainer [3]
through the guides of the plastic cover
and the strap loop.
Figure C:
Keep the metal retainer positioned
between your thumb and forefinger.
Slide the plastic cover backwards onto
the metal frame as indicated until both
ratchets [4] locks with a distinct clicking
sound into the detentions in the metal
frame.
Figure D:
Check by pulling both stress taking
straps [2] and [2`] the adjustment device
will lock safely.