Schroth Racing QuickFit And QuickFit Pro BMW E82 / E92 / E92 LCI - Manual (Page 10)

10
• As a constant reminder, the enclosed transparent sticker
must be attached to the rear side window in a prominent
place. The sticker cannot be removed without damage to
chromate tinted glass. On such vehicles, you may affix the
transparent sticker at a different, prominent location so that
it will serve as a constant reminder.
10 Stowing the belts when not in use
If you use the stock 3-point belt instead of the SCHROTH
harnessbelt, be sure to properly stow the SCHROTH harness
belt so that it is not exposed to seat tracks, liquids, sun light, or
any other area where the belt could possibly be damaged.
When not in use we recommend that you unhook all four points
are remove the entire belt for proper storage.
11 Using the Quick Fit Pro with a HANS® Device
The geometry of the Quick Fit Pro creates optimum capture of
the HANS® device and provides for the occupant the highest
level of Head and Neck restraint possible.
Always be sure your HANS® attachment points are installed
correctly in the helmet and that your device is in good working
order before using.
To use the Quick Fit Pro with a HANS® Device, be sure to
make note of the following points:
•
Install the belt as you would normally
•
Place the HANS® device on your shoulders
•
Carefully place the shoulder belts of the Quick Fit Pro
over the yoke of the HANS®
•
Be sure that the shoulder belt adjusters fall either
entirely on or entirely off the yoke of the HANS®. If
necessary, adjust the length of the tail strap to the
correct length.
•
Tighten lap belts and shoulder belts as you normally
would, making sure that the shoulder belts stay on the
yoke of the HANS® while doing so.
•
Once the belts are tight, they will stay on the HANS®
device without any further adjustments.
The following picture depicts correct use of the Quick Fit Pro
with a HANS® Device:
CARE and MAINTENANCE
1 Inspection
Check the safety belt once a month for any damage. Cuts,
tears and other damage to the belt will greatly reduce its
effectiveness. Replace the belt or damaged parts immediately
with original Spare Parts (see page 18, Spare Parts). Never
use a damaged harness belt, use the standard 3-point belts
which remain available for use.
Make sure the buckles are free of any obstruction and lock
securely.
Modified belts or such belts that have been resewn are not strong
enough and are dangerous in an accident.
Never modify, disassemble or repair the belts yourself.
For parts that can be replaced, use only original SCHROTH Spare
Parts.
Only original SCHROTH Accessories may be used with the
harness belt system.
Use of non-authorized parts and Accessories can reduce the
effectiveness of the harness belt system.