Schroth Racing QuickFit And QuickFit Pro BMW MINI (2001-2006) - Manual (Page 11)

11
2 Accident
A safety belt which was in use during an accident has
been weakened and is unfit for further use and must be
replaced! One indication that the belt was exposed to
excess strain and therefore requires replacement is when
the stitches of the asm-system are ripped open and are
protruding from underneath the asm-plastic cover.
A restitched asm seam is dangerous.
The asm energy conversion device may not be restitched
under any circumstances.
After an accident, in addition to replacing seat belt which were
in use, also be sure to ask your car dealer for carefully check
all seatbelt attachment points for deformation or cracks.
Always make sure that the guidelines of the car manufacturer
are followed if a repair is necessary.
3
Re-assembling the length adjuster
We do not recommend to disassemble the length adjuster
during installation process. Even to run the harness belt
through the openings at racing seats disassembling is
not necessary.
If for any reason the length adjuster is disassembled, strictly
follow the procedure step by step as described below to re-
assemble the adjuster.
4 Cleaning
To clean the belt, use soap and warm water. Do not use any
solvents! Do not dry the belt in the sun or near a radiator.
Improper cleaning or drying of the harness belts can
weaken them, reduce their effectiveness and can result in
serious personal injury or death.
5 Installation Accessories
Color key:
black=0, blue=1, red=2, yellow=3, purple=5, green=8
The X in PINs must be substituted by the color key of the color you want to order!
Shoulder belt pads, pair of
black with yellow flock printing 00109
Shoulder belt pads, pair of blue with black flock printing 01109
red, yellow, purple, green with black flock printing 0X109
Shoulder belt pads, pair of black with gray flock printing 09109
Shoulder belt pads, pair of silver-gray w. black flock printing 09209
Shoulder belt pads, pair of black with black flock printing 09309
Adjusting grips for length adjuster, 4 pcs./package 00092
6 Spare
Parts
If any part of your harness needs replacement, please contact
your nearest dealer. USE ONLY GENUINE SCHROTH
PARTS.
Cover for adjuster inclusive retainer
01084
7
MINI Quick-Fit Part Numbers
Verify you have the correct belt for your MINI. The following
part numbers apply only to MINI Quick-Fit Rallye 4 Belts.
MINI Quick Fit Rallye 4
Black Left 16150
MINI Quick Fit Rallye 4 Black Right 16650
MINI Quick Fit Rallye 4 Blue Left 16151
MINI Quick Fit Rallye 4 Blue Right 16651
MINI Quick Fit Rallye 4 Red Left 16152
MINI Quick Fit Rallye 4 Red Right 16652
8
MINI Quick-Fit Pro Part Numbers
MINI Quick Fit Pro
Black Left 18150
MINI Quick Fit Pro Black Right 18650
MINI Quick Fit Pro Blue Left 18151
MINI Quick Fit Pro Blue Right 18651
MINI Quick Fit Pro Red Left 18152
MINI Quick Fit Pro Red Right 18652