Schroth Racing Rallye Cross - Manual (Page 6)

3 Installation of the lap belt
When mounting the lap belt in a car
equipped with a racing seat and integrated
(non adjustable) headrests thread the belt
through the openings as illustraded.
3.1 Re-assembling the length adjuster
W A R N I N G !
We do not recommend disassembly the length
adjuster during installation process. It is possible to
run the harness belt through the openings in racing
seats without disassembling the harnessbelt.
If for any reason the length adjuster is disassembled, strictly
follow the procedure step by step as described below to re-
assemble the adjuster.
3.2 Installation
locations
at or on the center tunnel
8
Make sure that the seat and bracket are positioned so that
moving parts of the seat or adjustment mechanisms cannot
contact or damage the webbing of lap belt.
(See paragraph 4, Flexibility range of the seat belt
mounting brackets.)
at the seat
on the seat sliding bracket
Mounting point on Illustration shows
sliding anchor point AUDI/VW installation.
on the seat bracket
of seat with height
adjustment.
at the door sill
Use the foremost anchor point of the sliding
bar of the stock 3-point belt.
4
Flexible range of the seat belt mounting brackets
W A R N I N G !
Repeated bending could weaken the bracket and
cause it to fail when loaded in an accident.
Never bend the bracket back and forth several times.
Any pivoting brackets of the stock 3-point belts must
not be limited in their range of motion.
9
Figure A:
Fold the strap to a loop and insert it
upwards throughout the metal frame and
turn the loop as indicated.
Note:
The strap part protuding from the
adjuster for further adjustment [1] must
be located above the stress taking strap
[2].
Figure B:
Position the plastic cover on top of the
loop and insert the metal retainer [3]
through the guides of the plastic cover
and the strap loop.
Figure C:
Keep the metal retainer positioned
between your thumb and forefinger.
Slide the plastic cover backwards onto
the metal frame as indicated until both
ratchets [4] locks with a distinct clicking
sound into the deepenings at the metal
frame.
Figure D:
Check by pulling both stress taking
straps [2] and [2`] the adjustment device
will lock safely.