Schroth Racing Rallye Cross - Manual (Page 5)

W A R N I N G !
Use of improper attachment points will
impair system performance.
Weak tail strap anchor points will not withstand the
forces in an accident and increase the risk of per-
sonal injury in an accident.
Never attach the tail strap to anchorages intended for
the tether straps of child seats which are found on
the filler panels behind the rear seats of some pas-
senger cars or the luggage area of some hatchbacks
or station wagons. These anchor points are not
strong enough to withstand the forces of an accident
and are not intended for adult safety belts.
Harness belt systems may only be installed at suit-
able anchor points for seat belt systems as originally
installed by the vehicle manufacturer.
For suitable anchor points for make, model and
model year of your vehicle, see Vehicle Reference
List. If in doubt, ask your dealer to show you where
these anchor points are located.
These figures show the general location and suitabilities of seat
belt anchor points installed as standard equipment in passenger
cars.
Rallye 3 only:
Not suitable for attachment of a SCHROTH Rallye 3.
Must be used for the attachment of the lap belt portion of
the harness belt.
Suitability for tail strap anchorage of Rallye 3 depends
upon the specific make, model and model year of the
vehicle. Never install the tail strap at the anchor point "D"
unless it is used with an approved seat. (See index in
Vehicle Reference List.)
SIDE VIEW
Figure 1
OVERHEAD VIEW
Figure 2
6
Not suitable for attachment of a SCHROTH Rallye 4 and
Rallye Cross.
Must be used for the attachment of the lap belt portion of
the harness belt.
Suitability for tail strap anchorage of Rallye 4 and
Rallye Cross depends upon the specific make, model and
model year of the vehicle. Never install the harness belt
unless it is used with an approved seat. (See index in
Vehicle Reference List.)
SIDE VIEW
Figure 1
OVERHEAD VIEW
Figure 2
W A R N I N G !
Never drill or tap or make a new attachment point in
the body or chassis in order to mount a SCHROTH
harness at that location. Such attachment points are
inadequate, may be improperly located and can
seriously impair the function and effectiveness of the
system.
Please compare the possible mounting locations on your car
with the illustrations on pages 6/7 and pick the one that you find
most suitable.
Original equipment belts with swivel attachments must never be
bent, modified, impeded or restricted in their range of motion.
2 Anchorage bolts
Bolts used to attach original equipment seatbelts may be used
to attach the SCHROTH asm harnessbelt if they are long
enough. You must be able to tighten each bolt a minimum of
nine (9) full 360 degree turns. If the bolt is too short, choose one
of the SCHROTH supplied bolts. (Read and observe the
following Warning!) Tightening torque for all bolts: 30 ftlbs (40
Nm)
W A R N I N G !
A bolt which sticks out too far might damage the
chassis, the fuel tank, fuel lines, brake lines or other
important vehicle components.
Make sure enough space is available behind the
thread before screwing in the 1½ inch (38 mm) long
bolt.
7
X
X
X
X
X
X
X
X X X
X
X