Buffalo Technology WHR-HP-AG108 - Manual (Page 3)

1
. Attach the antenna to the top of your AirStation. It
will usually work best if configured to point straight up.
Attach the stand if desired.
2
. Ensure that all equipment is powered off, including
the AirStation, PCs, and your cable or DSL modem.
3
. Connect the Ethernet cable from your cable or DSL
modem to the WAN port on your AirStation. The WAN
port is the port closest to the power connector. This is
the only port that will work for your internet connection.
4
. Connect a PC or workstation to any of the four LAN
ports on the AirStation with the included Ethernet cable.
5
. Power on the cable or DSL modem. Allow at least a
minute for the device to boot up.
6
. Connect the AC power connector to the power port
on the AirStation and to an AC surge protector or other
source of AC power. Allow the AirStation one minute to
boot.
7
. Power on the PC(s) connected to the LAN ports of the
AirStation and let them boot up completely.
Step 1: Connect Your Equipment
Ethernet cable to PC
Ethernet cable to
Cable/DSL Modem
AC Power