Condensed instructions – Blaupunkt RDM 169 US User Manual
Page 4
4
2
ON
Switching on the unit
Insert the KeyCard and press ON brief-
ly.
The unit is switched on in the last op-
erating mode selected and with the
previously selected volume.
Switching off the unit
Press ON for approx. 1 second.
The display can be adjusted for the de-
sired viewing angle in order to improve
legibility. Refer to “Improving the legi-
bility of the display” if necessary.
Switching the sound on/off
Press ON briefly. “MUTE” appears on
the display when the sound is switched
off.
To switch the sound back on again,
turn the volume knob
3
.
Condensed instructions
1
Disengaging the fold-down control
panel
Disengage the control panel to insert
or remove the KeyCard and CD.
To disengage the control panel, press
knob
1
: the control panel folds down.
The control panel cannot be removed,
nor should it be used a shelf.
To re-engage the control panel, push it
back into its original position (Arrow 3).
2
1
3
For safety reasons, the control
panel must always be engaged
whilst the vehicle is moving.
When leaving the vehicle, open the
control panel and remove the Key-
Card in order to prevent theft.
Switching the unit on/off using the
KeyCard
Insert/remove the KeyCard to switch
the unit on and off.
Refer also to the description of the
KeyCard anti-theft system
@
in the
condensed instructions.
Switching on/off by the ignition
The unit may be connected up such
that it is switched on and off by the ve-
hicle ignition.
When the ignition is switched off, a
double beep reminds you to remove
the KeyCard before leaving the vehi-
cle.
Switching on whilst the ignition is
off
With the ignition off (and the KeyCard
inserted), proceed as follows to oper-
ate the unit:
Press ON when the double beep
sounds.
The unit is switched on.
The unit switches itself off automatical-
ly after an hour’s use in order to pre-
vent the vehicle battery from running
down.