S&S Cycle Single Bore Tuned Induction Kit for 2008-Up Touring Models with Electronic Throttle Control - Manual (Page 4)

4
NOTE: The longer “black chrome” screw goes in the bottom hole of the
cover.
12- Position the remaining gasket onto the two “black chrome” screws
as shown in Picture 11.
NOTE: Make sure the notch in the gasket lines up with the dowel pin hole on
the adapter plate as indicated in Picture 11.
13- Mount the intake runner assembly onto the throttle body ensuring
that the gasket from step 12 stays in position. The assembly will
“snap” into place as the two plates are aligned by the dowel pins on
the spacer plate.
14- Place a small amount of blue thread locker on both “black chrome”
fasteners and screw them into the throttle body. Torque them
both to 25-30 in-lbs.
15- Install the air filters and clamps onto the intake runner assembly.
Press the air filters on approximately 1-inch from the tube ends.
Tighten the clamps with a standard screwdriver or 5/16” nut driver.
16. Apply the label containing the CARB EO number to the front frame
down tube in a location above the factory label. See Picture 14.
NOTE: If the motorcycle is equipped with fairing lowers then it may be
necessary to remove the glove-box from the fairing lowers.
Picture 11
Picture 12
Picture 13
Picture 14
CARB label here