S&S Cycle Single Bore Tuned Induction Kit for 2008-Up Touring Models with Electronic Throttle Control - Manual (Page 3)

3
NOTE: There are two different diameters on the banjo-style vent, so be
sure the larger diameter is facing towards the head as shown in Picture 7.
4- Slide one spring clamp over the short end of the breather hose
and insert the breather hose over the breather tube located on the
back side of the spacer plate that you mounted to the throttle body
in step 2. Use pliers to open the spring clamp as the breather hose
is pushed over the breather tube. Be sure that when the spring
clamp is released it is positioned directly over the breather tube for
maximum clamping and sealing.
5- The breather hose will extend past the banjo-style vent fittings on
the head as shown in Picture 8. Measure and cut the hose so it will
slide all the way onto the vent fitting with out kinking the hose
shut when correctly installed.
6- After the breather tube has been cut, slide the remaining two
spring clamps over each end of the breather tube. Again, use pliers
to open the spring clamp as you slide the breather tube onto the
banjo-style vent fitting. Now torque the bolts holding the banjo-
style fittings on the heads to 12-14 ft-lbs. The completed breathing
system should be as shown in Picture 10.
7- Now moun t the intake runner to the throttle body by following
the remaining steps.
8- Place a clean rag on a flat surface and lay the intake runner face
down on the rag.
9- Place one intake adapter gasket on the gasket surface of the intake
runner followed by the plastic cover, the remaining intake adapter
gasket, and then the adapter plate. Refer to Figure 1 to help
ensure the proper order of components.
10- Secure the parts placed into position in step 9, by sliding the three
zinc plated ¼”-20 x .75” countersunk socket screws into the three
corresponding intake runner holes. Apply a small amount of blue
thread locker to the screws and torque each screw to approximately
55-60 in-lbs.
11- Pick the assembly up and slide the two “black chrome” ¼”- 20 x 1”
and ¼”- 20 x 1.5” countersunk allen screws and washers in through
the face of intake runner cover.
Picture 7
Picture 8
Picture 9
Picture 10
Figure 1