S&S Cycle Single Bore Tuned Induction Kit for 2008-Up Touring Models with Electronic Throttle Control - Manual (Page 2)

2
Thank you for choosing S&S® Cycle’s tuned induction runner kit for
all stock 2008-Up H-D® Touring motorcycles with electronic throttle
control. The following steps will help guide you through the proper
installation of the kit.
CAUTION
•
Tuning is generally not required for motorcycles equipped
with closed-loop EFI systems. If tuning is required due to other
engine modifications then consult a professional tuning center
for assistance.
•
If you are not certain of your capabilities or do not have the
correct tools for this installation, please consult a shop to have it
done for you. Improper installation of this product could result
in damage to the motorcycle and motorcycle components.
Tool Requirements
•
3/16” Allen Wrench
•
5/32” Allen Wrench
•
Pliers
•
Blue Threadlocker
•
5/16” Nut Driver or Standard
Screwdriver
•
3/8” or 1/2” Ratchet
•
7/8” Socket or Wrench
•
3/8” or 1/2” Drive Torque Wrench
INSTALLATION
1- Remove the stock air cleaner cover and backplate assembly from
the motorcycle so there is direct access to the throttle body as
shown in Picture 3.
2- Install the throttle body gasket and spacer plate to the throttle
body using the two supplied ¼-20 x .75” chrome socket head cap
screws. Torque both screws to approximately 55-60 in-lbs. See
Picture 4 and 5.
3- Lightly fasten both banjo-style vent fittings to each cylinder head
using Picture 6 to help determine the layout of fasteners and how
they should be installed. Be sure to note the placement of the two
different rubber-coated washers.
Picture 3
Picture 1
Picture 2
Single bore tuned induction intake kit available in wrinkle
black or chrome plated finishes. Filters available in red or
blue.
Picture 4
Picture 5
Picture 6
Note:
• Included with this kit
is a label containing a
CARB EO number. This
EO label is required
for use on 2008-2014
pollution controlled
motorcycles.