S&S Cycle In-Tank Fuel Pump - Manual (Page 5)

5
9. Install the banjo fitting on the hollow fuel fitting. Take care not to abrade o-rings during installation.
10. Orient the outlet of the banjo fitting to the desired location, install the banjo nut, and torque to 35–40 in-lbs.
11. If installing the pump using a mounting plate, install the gasket, and mounting plate/fuel pump assembly. Again, be sure that the fuel filter
sits at the bottom of the tank and if blind holes or studs were not used on the mounting ring, be sure to apply a gasoline/alcohol compatible
sealing compound to the threads of the fasteners.
12. After sealing compounds have cured, pressurize the tank and check for leaks.
Fuel Pump Electrical Connections (See Figure 5, next page)
The electrical connector supplied with the fuel pump mates with Packard® part number 12047786. You must obtain this connector separately. If
you prefer to use another connector, it is recommended that the connector either be sealed or the terminals be greased to avoid corrosion. Do
not apply power to the fuel pump at this time.
The schematic in Figure 5 shows the recommended wiring for the fuel pump when used with S&S, Delphi® style ECMs:
55-5029 – Serial ECM (55-5034 kit part number)
55-5069 – USB ECM (55-5090 kit part number)
If you are using this fuel pump with another control system, please contact the manufacturer for recommendations. Be sure that the fuel pump
is fused appropraitely (15 A maximum).
Note in the schematic that the low fuel indicator circuit requires the use of a 12V, 3.4W incandescent bulb. An LED will not work with this circuit.