S&S Cycle Single Bore Induction System - Manual (Page 6)

6
10- Connect the Injectors to the manifold with a light squeezing action. Lubricate the O-rings with clean engine oil. Once in place, use Loctite® 222
on the threads of two 8-32 x 5/8” slotted panhead screws and tighten to 15-20 in-lbs.
11- Install the backing washer and O-ring on the fuel supply tube. Lubricate the O-ring with clean engine oil. When the tube is in place, position the
Y-shaped clip on the fuel rail and tighten the Loctite 222 coated T20 Torx button head M4 x 7 x 12mm screw to 18-23 in-lbs.
12- Gently push the injectors downward toward the manifold to increase clearance for connecting the wire connectors. Cut the existing injector
connectors from the motorcycle harness. Slide the sleeveing onto the injector harness. Slide heat shrink tubing on to each wire of the injector
harness wires. Crimp the butt splices to the motorcycle harness. Move the heat shrinks over the splices and shrink with a heat gun. Slide the
sleeve into place.
Picture 10
Picture 11a Picture 11b
Picture 12 Picture 12a