S&S Cycle Single Bore Induction System - Manual (Page 4)

4
5- Slide the MAP sensor in place, being sure not to pinch the orange rubber seal—some clean engine oil may make this easier. Install the cable
guide and verify it is aligned with the throttle cable actuator. Once alignment is satisfactory, apply Loctite® 222 to the 10-24 x 1/4” screws and
tighten to 18-22 in-lbs.
4- Install the new O-ring into the throttle body. A light film of clean engine oil can be used to help hold the O-ring in place. Align the manifold to
the throttle body, use purple 222 Loctite® on the 10-24 x 1” socket-head assembly screws (with flat washers) and tighten them to 35-40 in-lbs.
6- Using the new S&S® supplied gasket, slide the S&S supplied intake air temperature (IAT) sensor in place. Use Loctite 222 on the T10 Torx
button head M3 x .5 x 10mm screws and tighten to 6-8 in-lbs.
Picture 4
Picture 5
Picture 6