S&S Cycle 114 Big Bore Kit for Victory Motorcycles - Manual (Page 2)

2
KIT CONTENTS:
2 – 4.125” (104.77mm) pistons matched to cylinders
•
2 – piston pins
•
2 – Piston ring sets for front and rear pistons
•
4 – Piston pin clips
•
2 – Head gaskets
•
2 – Customer owned Victory® cylinders sleeved and machined
•
1 – Calibration card for S&S®/Victory dealer downloading
•
ADDITIONAL PARTS REqUIRED:
2 – 5244365 Stock Victory base gaskets
•
2 – Stock Victory rocker cover gaskets for the specific model you’re working on
•
4 – 7663008 Stock Victory cylinder alignment dowels
•
2 – Stock Victory cylinder head exhaust gaskets for the specific model you’re working on
•
1 – Stock Victory cam cover gasket for the specific model you’re working on
•
Any other o-rings, gaskets, assembly lube, and oil called out in your Victory Service Manual for performing an engine build and installation into
•
the specific motorcycle your working on.
SPECIAL TOOL REqUIREMENTS:
Victory service manual – Available through Polaris® dealers
•
S&S Freedom Performance Tuner – Available to authorized S&S/Victory dealers
•
Piston C-clip installer
•
Piston ring compressor
•
Piston ring expander
•
Piston ring end gap filing tool
•
Digital or dial calipers
•
Feeler gage
•
The safety of the motorcycle rider is dependent on proper installation of this product. If you are not certain of your capabilities or do
•
not have the correct tools for this installation, please consult a dealer to have it done. Improper installation of this product could result
in injury or death to the rider.
Be sure to disconnect the battery of your motorcycle before starting on this procedure. Accidental starting of the motorcycle could
•
cause injury to you or others around you during the installation.
S&S Big Bore Kit
WARNING