S&S Cycle Billet Air Cleaner Kit PN 106-5131 for Victory Motorcycles - Manual (Page 9)

9
11– Re-secure the wiring harness to its original location on the right side frame rail. Picture 19 illustrates the assembled S&S® air cleaner and wiring
harness positioned back in the original location.
Idle Air Control Bracket, Supply and Delivery Hose Installation
1 – With the Idle Air Control (IAC) bracket, supply and delivery hose assembly on your work bench, measure back .500” from the end of the front
and rear air delivery hoses and mark with a piece of masking tape as illustrated in Picture 20.
Note: The tape that is placed on the air delivery lines will be your depth gauge for installing lines into the front 90° and rear “T” rubber fittings that
connect to the throttle body. If the air delivery lines are pushed to far into the rubber fittings they may bottom out and restrict air flow causing improper
function of the IAC.
2 – Route the air supply and air delivery lines between the cylinders and to the left side of the motorcycle just as they were routed before
disassembly. Mount the IAC bracket to its original location, to the front and rear heads, on the right side of the motorcycle with the four socket
head cap screws that were removed at disassembly. Tighten fasteners to 85 inch pounds.
3 – Push the front and rear air delivery lines in .500”, or up to the masking tape that was attached in step 1, into the rubber 90° and “T” fittings that
are attached to the throttle body. Once installed remove masking tape.
4 – Locate the black .660” spring clamp, illustrated in Picture 21, from the S&S supplied hardware pack.
Picture 19
Picture 20
Picture 21
.500"
.500"
Masking Tape