S&S Cycle Billet Air Cleaner Kit PN 106-5131 for Victory Motorcycles - Manual (Page 6)

6
Removing the Victory® Air Box
1 – The use of a PVC pipe wire saw as illustrated in Picture 12 works best for removal of stock Victory air box.
2 – Remove the air filter cover and the air filter element from the stock Victory air box
3 – Thread the wire saw between the frame rails as illustrated in Picture 13, 14, and 15.
Always wear eye protection while cutting or sawing to avoid injury to the eyes.
4 – Before making the first cut make certain you are wearing safety glasses or protective eyewear. With the wire saw in place, make sure there are
no wires or cables between the wire saw and the air box; work the saw back and forth cutting the air box from the top down and at an angle
toward the Idle Air Control plastic supply barb, cutting the air box into two pieces. Once the first cut is made, the rear section of the air box
should be removed.
Picture 12-PVC Wire Saw
Picture 13
Picture 14 Picture 15
WARNING
Wire Saw