S&S Cycle Ignition System For All 1999–03 Carbureted Harley-Davidson Twin Cam 88 Engines - Manual (Page 7)

7
a. Route the wiring harness along the bike frame to ensure that the Ignition Module Connector (a) See Picture 9, previous page reaches the
Module mounting location.
b. Connect the Ignition Module Connector (a) See Picture 9 to the Module.
c. Install the module using the stock mounting hardware and the S&S hardware (if necessary) included with the module.
d. Plug the 12-socket black and gray plugs from the stock Harley-Davidson® wiring harness into the corresponding gray and black 12-pin
Motorcycle Main Harness Connectors (b & c) See Picture 9 on the S&S harness. See Picture 10, below.
e. The remaining portion of the harness that connects to the Head Temperature Sensor and the Knock Sensor should be routed along with the
stock wiring under the gas tank.
f. Connect the Head Temperature Connector (e) See Picture 9 and Knock Sensor Connector (d) See Picture 9 to the corresponding sensors.
g. Use the provided wire ties to secure this portion of the harness to the motorcycle frame or a portion of the existing harness.
NOTE: If the tank is removed or raised, temporarily replace it to insure clearance for the Engine Temperature and Knock Sensor portions of the harness.
Reroute any wires that may be damaged by installing the tank.
h. Permanently reinstall tank, reconnect battery (positive cable first) and any other portions of the motorcycle that have been removed or
disconnected.
Picture 10