S&S Cycle Chain Drive Camshaft for 2007-Up Big Twin and 2006-Up Harley-Davidson Dyna - Manual (Page 6)

6
Final Assembly
1- Place primary chain over the rear cam sprocket. Install the crank sprocket into the primary chain so that the timing marks on both sprockets
are aligned as shown in Picture 6.
2- Install the primary timing chain assembly onto the crankshaft and rear cam.
NOTE: Align the crankshaft and rear cam so that the primary timing chain assembly fits so that the timing marks are aligned.
3- Thoroughly clean the flange bolts and apply a small amount of Loctite® 262, 271 or 272 to the threads. Apply a drop of clean
20W-50 engine oil under the bolt flange.
4- Install the sprocket locking tool and torque the crankshaft gear bolt and tighten to 25 ft-lbs. Install the camshaft gear bolt
and tighten to 34 ft-lbs. torque.
5- Install primary cam chain tensioner, tighten fasteners to 100-120 in-lbs.
6- Inspect the blind tapped holes for the cam cover in the crankcase for cleanliness. Remove any foreign debris.
7- Install cam cover with new gasket. Torque the 10 bolts to 125-155 in-lbs in the sequence shown below.
8- Remove the clips holding the tappets in place.
Picture 7
7
6
4
10
8
1
9
5
3
2
Picture 6