Robustel M1000 UP User Guide - Manual (Page 13)

Robustel GoRugged M1000 UP User Guide
RT_UG_M1000 UP_v.1.0.0
17.10.2013 12 / 39
Note: Normally, current/voltage output of PC’s USB 2.0 interface is only 0.5A/5V. So when you use USB interface for
sending/receiving data, you should use power input interface for power supply (please check section 2.8).
2.4 Install SIM Card
Be sure to insert a SIM card before you use the modem.
Note: A SIM card set with PIN code cannot be used normally in the modem without the correct PIN code.
Make sure to disconnect the adapter and switch off your modem before inserting or removing your SIM/USIM card.
 Inserting SIM Card
1. Make sure your adapter is disconnected.
2. Insert the SIM card, and you need press the SIM card with your fingers until you hear “a cracking sound”.
 Removing SIM card
1. Make sure your adapter is disconnected.
2. Press the SIM card until you hear “a cracking sound”, then the SIM card will pop up to be pulled out.
Note:
1. Don’t touch the metal surface of the SIM card in case information in the card is lost or destroyed.
2. Don’t bend or scratch your SIM card. Keep the card away from electricity and magnetism.
3. Make sure to disconnect the power source from your modem before inserting and removing your SIM card.

USB