RKI Instruments Beacon 110 - Manual (Page 12)

8 Beacon 110 Operator’s Manual
Status LEDs
The Beacon 110 includes three active status LEDs that are located above the display (see
Figure 1). Two LEDs, labelled RX and TX, to the right of those described below, are not
active.
• Fail LED
The fail LED turns on when the Beacon 110 is experiencing a fail condition. A fail
condition can be caused by a detector failure or low detector signal.
• Alarm 1 LED
The alarm 1 LED is on when the Beacon 110 is experiencing an alarm 1 condition.
• Alarm 2 LED
The alarm 2 LED is on when the Beacon 110 is experiencing an alarm 2 condition.
ENTER • Initiates operations
• Enters Configuration Mode (press with UP/YES button)
• Accepts displayed parameters
Table 4: Beacon 110 Control Button Functions
Switch Function