RKI Instruments GX-2001 Canadian Version - Manual (Page 26)

26 • Setting the Time and Date Model GX-2001 Operator’s Manual
Setting the Time and Date
The Model GX-2001 allows you to set the time and date.
1. Make sure the Model GX-2001 is turned off. The LCD should be blank.
2. Press and hold the DISP button, then press and hold the MODE/
POWER button to put the Model GX-2001 into Time Adjustment Mode.
Release the buttons when the unit beeps. The LCD shows the year,
month, day, and time. The year is flashing at the top of the LCD.
3. To change the time and date,
• Use the MODE/POWER button to cycle through the time and date
values.
• You can only change a value if it is flashing.
• Use the AIR button to increase a value.
• Use the DISP button to decrease a value.
NOTE: Once you have cycled though the time and date values, the Model
GX-2001 will go into Start-up Mode followed by Measuring Mode.
If you want to cycle through the time and date values again, press
and hold the MODE/POWER button to turn off the Model GX-
2001. Then begin with step 2 above to put the unit back into Time
Adjustment Mode.
4. To leave Time Adjustment Mode, press the MODE/POWER button to
cycle through to the end of the time and date values. The Model GX-
2001 then enters Start-up Mode followed by Measuring Mode.
2 0 0 0
11.13
21:06
Year
Month Day
Hour Minute
Figure 5: LCD in Time Adjustment Mode