Blaupunkt STOCKHOLM RCM 126 - Manual (Page 23)

52
of at least three seconds between the indi-
vidual titles.
Switching the tape side
(autoreverse)
To change the tape direction during casset-
te playback:
•
Press .
At the end of a tape side, the mechanism
changes directions automatically to play the
other side (autoreverse). The display shows
“TR1-PLAY” for track (side) 1 or “TR2-PLAY”
for track 2.
Notice:
If there is too much tension on the tape
during playback, the set may switch over by
itself before having reached the end of the
tape side. In this case check the condition
of the cassette tape. Sometimes it helps to
rewind it completely.
Tape equalisation
When a metal or CrO
2
tape is inserted, the
tape mechanism automatically adjusts to
metal/CrO
2
tape equalisation.
The “MTL” indicator will illuminate.
Scanning cassette titles with
SCAN
You can have the cassette titles played
briefly by using the scan function. If you like
a title, stop the scan to continue listening to
that track.
To start/stop the scan function:
•
Press the SC button briefly.
You can individually adjust the scan time in
the DSC menu (see “DSC programming -
SCANTIME”).
Dolby B NR*
With this unit you can play back tapes re-
corded with Dolby-B NR or without noise
reduction.
Cassette tapes recorded with Dolby NR*
stand out by their reduced tape hiss and the
improved dynamics.
If Dolby-B NR is switched on, “B” will light
up in the display.
To switch on/off:
•
Press B (not during scan operation).
.
* Noise Reduction system manufactured under licen-
se from Dolby Laboratories Licensing Corporation.
“Dolby” and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
Skipping unrecorded tape por-
tions with Blank Skip
This function senses an unrecorded tape
portion continuing for more than 15 seconds
and automatically fast forwards the cas-
sette to the beginning of the next track.
During fast tape winding, “B-SKIP” will be
indicated on the display panel.
To switch the Blank Skip function on and
off:
•
Press the RM button for approximately
one second until you hear a beep.
When the function has been activated, “BLS”
will appear in the display.
Listening to the radio during fast
tape winding with RM
(Radio Monitor)
When the tape is fast forwarded or rewound
(also with S-CPS), the radio will normally
be muted. To listen to the radio during fast
winding, activate the Radio Monitor function.
To switch RM on and off:
•
Press RM.
When the function is active, “RM” will light
up in the display.
Stockh. RCM126 gb® 30.04.2002, 15:25 Uhr 52