Blaupunkt STOCKHOLM RCM 126 - Manual (Page 20)

49
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Traffic Memo (TIM)
This set is equipped with a digital speech
memory, making it possible to automatically
record up to four traffic messages lasting a
maximum of four minutes.
When the radio is switched on and “TP” dis-
played, the system will record all incoming
messages of the tuned in station.
If the priority for traffic announcements is
activated (“TA” shown on the display panel),
the set will also record the messages broad-
cast by the traffic station of the programme
network (see also “Receiving traffic pro-
gramme stations with RDS-EON”).
Depending on the length of the new messa-
ge, the oldest messages are automatically
deleted.
If a message is longer than four minutes,
“OVERFLOW” will be displayed after four
minutes of playback, followed by a beep tone
indicating that the system was unable to
record the message in full.
Warning note
Danger of damaging the antenna in a car
wash
If you have installed a motor antenna, then
please read the corresponding warning note
at the end of this chapter.
Setting the clock in the DSC
menu
TIM needs the exact time in order to opera-
te precisely. Note that the clock also has to
be reset after any interruption of the power
supply (flashing time display).
•
Press DSC and the time will be dis-
played.
• Press << to set the hours or >> to set
the minutes.
The value to be set is flashing.
To alter the value,
•
press the rocker switch / .
Once having completed the setting,
•
press or DSC.
Now the clock setting has been stored.
If you have pressed the
button, you can
immediately go on working in the DSC
menu.
Recalling stored traffic
messages
• Press TIM briefly.
For example, the display shows “NDR 2”
(station name or frequency), followed by
“T4
14.30” (T4 = 4th traffic message re-
corded at 2:30 p.m.).
If four traffic messages have been recorded,
T4 always represents the most recent bulle-
tin which will also be played back first.
If the traffic memory is still empty, “NO TIM”
will appear on the display panel.
If the display shows four dashes, the clock
has not been reset after the last interruption
of the power supply.
Use the rocker switch / to play back any
of the messages T1 to T4.
To repeat a message:
•
Press once.
To select one of the older messages (e.g.
to skip from T4 to T3):
•
Press as many times as required.
To select one of the more recent messages
(e.g. to skip from T2 to T3):
•
Press twice.
When keeping the left or right part of the
rocker switch << >> depressed, the mes-
sage text including its recording time will be
played back quickly in forwards or back-
wards direction.
Press TIM to switch off the function.
Stockh. RCM126 gb® 30.04.2002, 15:25 Uhr 49