Blaupunkt STOCKHOLM RCM 126 User Manual

Page 14

ENGLISH

DEUTSCH

FRANÇAIS

ITALIANO

NEDERLANDS

SVENSKA

ESPAÑOL

PORTUGUÊS

Scrolling through the broad-
casting networks (only FM)

You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of the broadcasting
networks can be received, you can scroll
through them in forwards direction pressing
>>, or backwards using the << button, e.g.
NDR 1, 2, 3, 4, N-JOY, FFN, ANTENNE ...
For this it is necessary that the stations have
been tuned in at least once and that “AF” is
active (lights up in the display).
For this purpose, you may start Travelstore
seek operation:
•

Press FM

for two seconds; the sys-

tem starts to run through the frequency
band.

If “AF” does not light up,
•

press AF.

With this, the requirements for selecting sta-
tions with << >> are fulfilled.

Changing the memory bank (FM)

You can shift between the memory banks I,
II and T in order to store stations and recall
them later.
The currently selected memory bank is in-
dicated in the display.

•

Press the FM

button as many times

until the desired memory bank lights
up in the display.

Storing stations

On FM, you can store six stations on the
preset buttons 1-6 for each of the memory
banks I, II and T.
On MW/LW, you can store six stations each.
•

Select the appropriate waveband with
FM

or M•L.

•

Tune in a station with the rocker switch
(either automatically / or manually
<< >>).

•

Press the desired preset button until
the radio resumes play after the mu-
ting (takes approximately two seconds,
confirmed by beep).

Now the station has been stored.
The activated preset button is indicated in
the display.

Notice:
Should you tune in a station which has al-
ready been stored before on another
memory bank, the corresponding preset but-
ton and the memory bank will briefly flash in
the display.

Seek tuning

Up
Down
Down in short intervals
(“AF” must be switched off)
Up in short intervals
(“AF” must be switched off)

Manual tuning with << >>

You can also tune in a station manually.

Condition:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).

If necessary, deactivate these functions:
•

Press AF or PTY.

Manual tuning:

•

Press << >>; the frequency will change
in short intervals in downwards or up-
wards direction.

When holding the right or left part of the rock-
er switch depressed, the frequency scan is
speeded up.

Stockh. RCM126 gb®

30.04.2002, 15:25 Uhr