Blaupunkt STOCKHOLM RCM 126 - Manual (Page 21)

50
TIM standby mode while the
radio is switched off
When the radio is off, you can set the TIM
timer such that the broadcast traffic messa-
ges will be automatically recorded at the
programmed times. To recall these messa-
ges, proceed as described above.
Programming the TIM standby
mode / TIM times
You can programme two TIM times
(TIMER 1 and TIMER 2).
For example, TIMER 1 could be the time
when leaving home in the morning, TIMER 2
the time when driving home after work.
The TIM times to be programmed should
correspond to the approximate times of de-
parture. The radio then records all traffic in-
formation broadcast for 90 minutes before -
and after - this time, i.e. lasting a total of
three hours.
Attention: During this period, a motor an-
tenna will remain extracted. Note the corre-
sponding warning note at the end of this
chapter.
1.5 hours
The motor antenna
will be extracted
start
adjusted
TIM-TIME end
1.5 hours
• Use the rocker switch / to select
“TIMER 1” in the DSC menu.
• Press << or >> to recall the adjusted
time.
If “TIM OFF” is displayed, the TIM
function is inactive.
• Press / to set the timer.
• Press << to set the hours and >> to set
the minutes.
Once you have completed the setting,
•
press or DSC.
The clock setting for TIMER 1 has been
stored.
Proceed in the same way to set the
TIMER 2.
When the radio is off, TIM will be active 90
minutes before and after the programmed
TIM times.
If TIM is activated, the radio will generally
stay on standby for three hours after having
turned it off, independent of the program-
med TIM times. When TIM is active, the dis-
play will briefly show “TIM ON” when turning
off the set.
Deactivating the TIM standby
mode
You can deactivate the TIM standby mode
separately for TIMER 1 and TIMER 2.
•
Press DSC when the radio is on.
• Use the rocker switch / to select
“TIMER 1” or “TIMER 2”.
• Then press the button and switch to
“TIM OFF” by means of the rocker
switch / (you will find this item be-
tween the clock settings for 23:00 and
0:00).
When “TIM OFF” is flashing,
•
press .
If you wish to deactivate both timers, pro-
ceed in the same way to switch the other
timer to “TIM OFF” as well.
When your motor antenna is retracted im-
mediately after having turned off the radio,
you can be assured that the TIM standby
mode is inactive.
Note:
The standby mode will be automatically
switched off if the car radio is not turned on
within 72 hours.
Stockh. RCM126 gb® 30.04.2002, 15:25 Uhr 50