Precisionsound Ukrainian Bandura User Manual
Page 3
© Copyright Precisionsound 2013
control knob. Delay: delay effect with Level control knob and on/off button. Other knobs control the
Time of delay, Feedback of the delay signal, Tone (filter frequency character of the delay), and Spread
(stereo width of delay signal, where 0%=mono)
Tremolo + Arp page.
Tremolo + arp control:
Rate knob with different host tempo synced speeds from 1/4 to 1/64 and a Free mode that activates
the Speed knob (on the right), so you can dial in a free tempo not dependent on the host.
The Tremolo + arp menu lets you activate either tremolo, or an arpeggio pattern. It can also be
controlled by keyswitch, where D#0 =Off, E0=Tremolo, F0= Up, F#0= Down, G0=Up and Down,
G#0=Down and Up. Note that arpeggio sounds the same as tremolo when only one note is held;
to take effect, the arpeggio requires at least two held notes.
Tremolo + arp On/Off is also controllable by Sustain Pedal (CC64), which when pressed will activate
the most recently used tremolo/arp mode.
Accelerate/Decelerate mode button, also controllable by keyswitch A0 (accelerate) and A#0
(decelerate). The Accelerate/Decelerate effect determines the effect of the modwheel (CC1) on the
tremolo and arpeggio. Therefore, it only works if the Tremolo + arp is on.
Tremolo + arp humanize:
Timing, Velocity & Tuning control knobs for a dead tight (0%) to more human randomization (100%)
of these characteristics of the Tremolo and Arpeggio. If Tremolo + arp is off, these knobs have no
effect.
Note that these humanise controls for the Tremolo and Arpeggio act in addition to the humanise
control on the Articulation + Tone page, if Trio is enabled.