Powertrax 9010 - Manual (Page 6)

6
Figure 2
Mark carrier, caps, adjusters at lock hole
ring gear end. Mark the carrier and bearing cap on the ring gear
side with one punch mark and on the other side with two marks
(Figure 2). The caps are not interchangeable! Also mark each
bearing adjuster directly under the lock hole with this same mark
to note its side and rotational position. This mark is very import-
ant to correct re-assembly!
4. Remove the adjuster locks. Be sure that each adjust-
er is marked at the lock hole with the correct number of punch
marks for each side. The adjusters are not interchangeable af-
ter they are marked for position! (In general, the adjuster locks
themselves are interchangeable.)
5. Remove the bearing caps.
6. Slide (tap) the adjuster up and out and remove the
bearing race on the ring gear side first and put a very small grind
mark on the outside of the race to mark it. Scraping it on a ce-
ment floor also works, or you can use a tag. Be sure that you can
identify it for proper re-assembly on the correct side!