Phoenix Audio Spider USB and SIP/IP Telephone MT505 User Manual
Page 9

VOLUME
Adjust the volume levels for the Spider’s different volume profiles listed below:
Speaker
Increase or decrease the speaker volume by using and
Microphone
Increase or decrease the microphone sensitivity using and
NOTE:
,f the volume is set too low you won’t be heard by the far-end. However, if the volume
is set too high, the far-end might get a distorted signal.
Ringer
Increase or decrease the ringtone volume by using
and
Ringtone
Scroll using the
and
buttons to choose a ringtone.
ADMINISTRATION
General device controls and settings.
Set Auto IP
Set a unit to receive an IP address automatically.
NOTE:
Used to gain access to a unit set to Static IP on a dynamic IP network.
Restore Defaults
Returns all settings to factory defaults.
Idle Display
Choose what is shown on the screen of the Spider when the unit is idle. “ID” is the name given
by the IP service provider, while “Name” can be configured via the CONTROL PORTAL (see
administrative manual).
Grill Light
Turn ON/OFF the blue and red lights that appear under the grill during a call (incoming call,
mute, beamforming, and hanging up).
Display Brightness
Scroll using the and
buttons to choose a display brightness setting.
Page 9