Phoenix Audio Spider USB and SIP/IP Telephone MT505 User Manual
Page 6

DURING A CALL
DIRECTIONAL ARRAY
During a call the Spider uses proprietary beamforming technology to locate a legitimate voice
source and steer an array towards it. This allows the Spider to focus on the speaker in the room
and to cancel out all other noises.
The beamforming process is dynamic and adjusts the direction of the array when the source of
sound changes or moves. When in a call and voice is detected in the room, a single or multiple
blue lights located under the grill will indicate which direction the Spider’s audio beam is
focusing on. This is the direction that will be heard best by the far-end of the call (the person you
are talking to).
NOTE:
This function can be disabled (see page 9).
CALL TIMER
In the top left corner of the screen you will see a timer that will start when your call is picked up
and will stop when the call is disconnected.
CALLER ID
The center of the screen will display the LQVHVVLRQSKRQHQXPEHU. If that number has a
caller ID name, the name will be displayed.
VOLUME CONTROL
Use the and buttons on the keypad to control the speaker volume.
MUTE
In order to mute the Spider’s microphones during a call, press the button located on the
bottom right of the keypad. When muted, a MUTE symbol will appear on the screen and all the
grill lights will flash red.
To UNMUTE, just press the button again.
TRANSFER CALL
(to transfer your call to a different phone)
Press the left function key
Dial the intended number to be transferred to
Press the left function key
once more to complete the transfer
Page 6