Phoenix Audio Spider USB and SIP/IP Telephone MT505 User Manual
Page 5

CONNECTING TO A SIP/IP LINE
For any session using an IP telephone provider (IP/SIP).
Using the Ethernet cable provided, plug one end of the cable into the Spider’s Ethernet
connector (located on the connector panel below the unit).
Plug the other end of the cable directly into your Ethernet wall socket.
Make sure that the Spider is either plugged into a power source OR that your home or
office is equipped with Power over Ethernet (PoE).
It is important that your Spider is registered with an IP service provider (See
Administrative User Manual).
USING THE SPIDER
DIALING
If keypad is dimmed, press any key to turn on the backlight
Dial the desired number
Press
OR
Press
to get a dial tone
The screen will display the last dialed number
Either select to redial by pressing
OR
dial the desired number
INCOMING CALL
When the Spider receives an incoming call, the display will notify you of the caller ID, a ringtone
will play, and the grill lights will flash blue.
TAKE CALL
Press
OR
the left function button
REJECT CALL
Press
OR
the right function button
(this will hang-up the call)
SILENCE CALL
Press the middle function button
(the Spider will continue ringing, only without
the audible ringtone)
Page 5