Orbit Baby Generation-one Car Seat Base - Manual (Page 20)

38
38 38
38 39
39 39
39
f) Secure the Lock-Off Clamp fi rmly
upon both portions of the lap-only
vehicle seat belt (Photo W).
Continue on to Step # 8.
8. Turn the StrongArm Knob at the front of
the Base clockwise. (Photo X)
9. CHECK the installation is secure by
pulling the Base in various directions
(Photo Y) – the Base Upright, where
the belt is secured, should not move by
more than 1 inch in any direction. If the
Base is loose, remove and re-install it
beginning at Step #2.
10.CHECK that the Base is level by looking
at the Level Indicator (Photo Z).
As you’re turning the Knob, the
StrongArm mechanism is amplifying
your strength and tightening the Base
into the car.
Each installation varies slightly, but
typically the Knob can turn about 10 full
revolutions.
You know that you have reached the
optimal tightness setting when the Base
Upright cannot move more than 1 inch
in any direction.
Installing the Base: With Vehicle
Seat Belts cont’d
Installing the Orbit Base Installing the Orbit Base
W
X
Y
Z