Orbit Baby Generation-one Car Seat Base - Manual (Page 17)

32
32 32
32 33
33 33
33
9. Pull on each LATCH Connector to be
sure it is locked onto the anchor (Photo
G).
10. Pull each LATCH Belt loop tight to
remove the slack and make sure the
Base is not loose (Photo H).
11. Turn the StrongArm Knob at the front of
the Base clockwise. (Photo I)
12. CHECK the installation is secure by
tugging and pulling the Base in various
directions (Photo J) – the Base should
not move by more than 1 inch in any
direction. If the Base is loose, remove
and re-install it beginning at Step #2.
13. CHECK that the Base is level by
looking at the Level Indicator (Photo K).
As you’re turning the Knob, the
StrongArm mechanism is amplifying
your strength and tightening the Base
into the car.
Each installation varies slightly, but
typically the Knob can turn almost 10
full revolutions.
You know that you have reached the
optimal tightness setting when the Base
Upright cannot move more than 1 inch
in any direction.
Installing the Orbit Base Installing the Orbit Base
Installing the Base: With LATCH
System cont’d
G
H
I
J
K