New Era FW-1-X FIRMWARE UPGRADE NE-1000X FAMILY OF SYRINGE PUMPS - Manual (Page 7)

NE-1000X 7 www.SyringePump.com
- Master pump starts infusing
- Second pump primes (if enabled), then pauses
- When the infusing pump reaches the overlap position, if enabled, or changes pumping direction, the paused
pump will start to infuse
- Sequence repeats:
- Refilling pump fills, primes, pausing and waits for the other pump.
- Infusing pump infuses to the overlap position or syringe empty, and then signals the other pump to start
infusing. When empty, changes direction and starts refilling
While Pumping
The pumping rate can be changed. The new pumping rate will be transmitted to the other pump, into the
corresponding pumping sequence.
Pressing the Stop key on either pump, will Pause the sequence on both pumps. Pressing the Start key will
continue pumping.
Notes
The refill rate needs to be fast enough so that the syringe is refilled and primed before the infusing pump has
emptied.
If the refilling pump is still pumping when the infusing pump empties, an error message will be displayed and the
pumps will stop.
Default Continuous Pumping Program
To load the default program: On the Master pump, while turning on power:
Press and hold the “Volume”/”Program Function” key until [Cont] is displayed. Press the “Volume” button again
to enter the selection.
Default Continuous Mode Pumping Parameters
Phase # Function Rate Volume
1 RATE Infusion 100.0 mL/hr Syringe 50.00 mL
2 RATE Refill 500.0 mL/hr Overlap 0.000 mL
3 RATE Prime 200.0 mL/hr Prime 0.100 mL
Communications Mode set to Continuous: [Cont]