New Era FW-1-X FIRMWARE UPGRADE NE-1000X FAMILY OF SYRINGE PUMPS - Manual (Page 4)

NE-1000X 4 www.SyringePump.com
ET:RS Reset all Event traps
RET End Sub-Routine and return to Phase after calling Phase number
BEEP Sound a single beep
n
OUT.0 Set program output logic pin low or high
CLR.D Clear total volume dispensed.
tr:Ft Temporary trigger input configuration. (“Ft” is configuration sub-menu)
3. Pre-Defined Program Selection
Press and hold the "Program Function" (Volume) key while turning on power to the pump. This will pre-load the Continuous
Pumping Program. See below for details.
In addition, this will set the pump’s RS-232 communication to Continuous pump control with a second NE-1000X syringe pump.
Cable CBL-DUAL-3 is required to control the second pump.
4. Example
Linear Ramp, Sub-Routines, Increment, Decrement
Rate 100 ml/hr
Decrease 100 ml/hr
Sub-Routine Calls
to Linear Ramp
Rate 500 ml/hr
Increase 200 ml/hr
Repeat Program
Rate 100 ml/hr
Phase Function Rate Volume Direction
1 RATE 100 ml/hr 1.0 ml Infuse
Phase Function Rate Time Direction
2 INCR 200 00:10 Infuse
Phase Function
3 JP:08
Phase Function Rate Volume Direction
4 RATE 500 ml/hr 5.0 ml Infuse
Phase Function Rate Time Direction
5 DECR 100 00:10 Infuse
Phase Function
6 JP:08
Phase Function
7 JP:01
Increase rate 200 ml/hr and
continue infusing for 10 seconds
Start Infusing at 100 ml/hr for 1 ml
Call Linear Ramp Sub-Routine
Decrease rate 100 ml/hr and
continue infusing for 10 seconds
Infuse at 500 ml/hr for 5 ml
Call Linear Ramp Sub-Routine
Repeat Program