Multiquip LT6K - Manual (Page 20)

page 20 — LT6K LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #1 (08/28/14)
components
Figure 3. Major Components 1 (Control Panel Side)
1
11
10
10
9
8
120/240 VAC ENGINE
HOURS OFF OFF
OFF OFF OFF
1/10
LIGHTING 120 VAC
4
5 6
3
7
2
3
Figure 3, 4, and 5 show the location of the controls and
components for the LT6K light tower. The function of each
component is described below:
1.
Ball Hitch Coupler — Attach the trailer's 2-inch coupler
to the towing vehicle. Use only the specified ball diameter
as indicated on your coupler. Use of any other ball
diameter will create an extremely dangerous condition
which can result in separation of the coupler and ball
or ball failure.
2. Tongue Jackstand — Use this jackstand to support the
tongue when attaching the light tower to a towing vehicle.
3. Side Reflectors — There are four reflectors located on
the side of the light tower. The front reflectors are amber
and the rear reflectors are red.
4. manual Holder — Contains information regarding the
light tower.
5. Panel Light — When the cabinet door is raised, the
light will automatically turn on. When the cabinet door
is closed, the light will turn off
6. Control panel — Contains the auxiliary output
receptacles, engine hour meter, excitation capacitor
and circuit breakers.
7. T-Bar — Allows the lights to be mounted vertically or
horizontally.
8. Engine — 3-cylinder, water cooled, direct injection,
12 HP diesel engine.
9. engine status module — Displays engine status via
LEDs, water temperature, air filter, fuel, alternator, oil
pressure, glow plugs. Insert ignition key, turn clockwise
to start engine.
10. Tie-Down Points — Used to tie down light tower with
straps or chains to allow even application of force to the
front and rear of the equipment during transport.
11. Chock Blocks — Place blocks (not included as part
of the light tower package) under each trailer wheel to
prevent rolling.