New Era NE-300 Just Infusion Syringe - Manual (Page 4)

New Era Pump Systems Inc.
www.SyringePump.com
Model NE-300 Syringe Pump
Copyright: New Era Pump Systems Inc. 1 08/27/14
1. General Information and Packing List
Thank you for purchasing the Model NE-300 “Just Infusion”™ Syringe Pump. With the NE-300 syringe
pump you will be able to digitally set an infusion rate for continuous pumping.
Please familiarize yourself with the NE-300’s operation by reading this user's manual. For future reference,
record the serial number, located on the rear of the pump, and the date of purchase.
New Era Pump Systems Inc., located in Farmingdale, NY USA, can be contacted at:
Phone: (631) 249-1392 FAX: (707) 248-2089 Email: [email protected]
WWW.SYRINGEPUMP.COM
This Operating Manual, and the NE-300’s hardware, electronics and firmware are copyrighted.
Copyright 1999-2014, all rights reserved.
Packing List
Included with the NE-300 Syringe Pump are the following items:
• One of the following external unregulated power supply adapters:
Input: One of: 120V AC 60 Hz, 220V AC 50 Hz, 240V AC 50 HZ
Output: 12V DC @ 800 mA (or compatible regulated power supply)
• This Operating Manual
1.1 Warnings ! and Cautions
!
Read the user’s manual
! No user serviceable parts are inside.
! Disconnect power from the pump when
connecting or disconnecting cables.
! Do not immerse the pump in liquid
! Install on a stable surface.
! Keep hands and loose clothing away from the
pump's moving parts.
! The pump can automatically start when the
Pumping Parameters is operating or when
attached to an external control device.
! Prevent liquids from entering openings in the
rear of the pump.
! Use only with the supplied power supply
connected to a power source as specified on the
power supply label.
! Do not push objects of any kind into the chassis
openings, except for appropriate cables and
connectors.
! If the pump becomes damaged, do not use unless
certified safe by a qualified technician. Damage
includes, but is not excluded to, frayed cords and
deterioration in performance.
!
Discharge static from control cables before
connecting by touching the cable to ground.
!
Before touching the pump, discharge static by
touching ground.
1.2 Disclaimer and Warranty
Disclaimer
New Era Pump Systems Inc. makes no representations or warranties, expressed, statutory or implied, regarding the fitness
or merchantability of this product for any particular purpose. Further, New Era Pump Systems Inc. is not liable for any
damages, including but not limited to, lost profits, lost savings, or other incidental or consequential damages arising from
ownership or use of this product, or for any delay in the performance of its obligations under the warranty due to causes
beyond its control. New Era Pump Systems Inc. also reserves the right to make any improvements or modifications to the
product described in this manual at any time, without notice of these changes.
New Era Pump Systems Inc. products are not designed, intended, or authorized for use in applications or as system
components intended to support or sustain human life, as a clinical medical device for humans, or for any application in
which the failure of the product could create a situation where personal injury or death may occur.
All brand and product names used in this manual are the trademarks of their respective owners.