Quick start instructions, Need more pumping features, Setup pumping parameters – New Era NE-300 Just Infusion Syringe User Manual
Page 2: Load the syringe, Purge, Start the pump, When pumping, Pump reset
New Era Pump Systems Inc.
www.SyringePump.com
Model NE-300 Syringe Pump
Copyright: New Era Pump Systems Inc.
i
08/27/14
Quick Start Instructions
•
Plug in the pump.
•
Press the power switch to turn on power.
•
Press any key to stop the display from blinking.
Setup Pumping Parameters
To Change Numbers:
•
Use the arrow keys to increment individual digits.
•
To set or clear the decimal point:
Simultaneously press the 2 up-arrow keys under the 2 digits next to the
decimal point position. Or, press and hold the left-most up-arrow key for at least 1 second. When the digit
increments from 9 to 0, the decimal point will begin to shift. Release the key when the decimal point is correct.
•
Press any non-arrow key, or wait 2 seconds, to enter the new setting. The display will blink when a new value is
entered and stored in memory.
Set the Syringe Inside Diameter:
•
Momentarily press the ‘Diameter’ key. Set the inside diameter of the syringe in millimeters (mm).
Set the Pumping Rate.
•
Momentarily press the ‘Rate’ key.
•
To change the
pumping rate units
:
−
Momentarily press the ‘Rate’ key again. The display will show:
−
While the units are blinking, press any arrow key to select the next available rate units.
−
Press any non-arrow key, or wait 2 seconds, to set the rate units.
•
Set the pumping rate. If the pumping rate is out of range, the display will show:
Load the Syringe
•
Press in the white drive-nut button to move the pusher block.
•
Lift and turn the syringe clamp away from the syringe holder block
•
Position the syringe on the pump with the flange to the left of the syringe holder block.
•
Lift and turn the syringe clamp onto the syringe body.
•
Move the pusher block next to the syringe plunger.
Purge:
Press and hold the ‘Start/Stop’ key for one second. Release to stop.
Press and hold the direction button to reverse the pump and release the pusher block if
jammed.
Start the Pump:
Press and release the ‘Start/Stop’ key to start or stop the pump.
When Pumping
• The pumping rate can be changed.
PUMP RESET:
PUMP RESET:
PUMP RESET:
PUMP RESET:
Press and hold the right-most up-arrow key while turning on power to the pump.
Need more pumping features?
Visit
www.SyringePump.com
to see our full-featured syringe pumps.