Multiquip CS8CE20H20 - Manual (Page 30)

PAGE 30 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)
3. Ensure the diamond blade has been mounted correctly and
that it is raised above the surface you are about to saw.
4. If operating the Cutter 3 CE in cold weather conditions ,
skip this step and proceed to step 5. Place the Choke Lever
(Figure 33) in the OPEN position. Skip to step 6.
The CLOSED position of the choke
lever enriches the fuel mixture for
starting a COLD engine. The OPEN
position provides the correct fuel
mixture for normal operation after
starting, and for restarting a warm
engine.
NOTE
5. If operating the Cutter 3 CE in cold weather conditions ,
place the Choke Lever (Figure 34) in the CLOSED position.
Figure 33. Choke Lever (Open Position)
Figure 34. Choke Lever (Closed Position)
6. Place the throttle lever (Figure 35) halfway between FAST
and SLOW for starting.
Figure 35. Throttle Lever (Fast Position)
7. Rotate the Engine Shutdown switch (Figure 36) to the
START position to engage the starter.
Figure 36. Ignition Switch (Start Position)
STOW CUTTER 3 CE SAW — ELECTRIC START-UP (20HP HONDA ENGINE)
Figure 32. Engine Start Switch (OFF Position)
8. Once the engine has started, slowly return the choke lever
(Figure 34) to the CLOSED position. If the engine has not
started repeat steps 4 through 7.
9. Before the saw is placed into operation, place the throttle
lever in the FAST position and run the engine for several
minutes. Check for fuel leaks, and noises that would associ-
ate with a loose guard and/or covers.
10. All cutting is done at FULL THROTTLE. Your engine gover-
nor has been set at the factory to ensure an optimum speed
setting.
OR