Multiquip CS8CE20H20 - Manual (Page 12)

PAGE 12 — STOW CUTTER 3 CE SAW — PARTS & OPERATION MANUAL — REV. #5 (09/22/06)
Machine Safety Decals
The Cutter 3 saws are equipped with a number of safety decals (Figure 2). These decals are provided for operator safety and maintenance
information. The illustration below shows these decals as they appear on the slab saws. Should any of these decals become unreadable,
replacements can be obtained from you dealer. See the "Nameplate and Decals" section for decal placement.
STOW CUTTER 3 CE SAW — DECALS
Figure 2. Stow Cutter 3 Saw Decals
CUTTER
3
CUTTER
3
P/N: 11246
P/N: 22972-003
P/N: 23653-003
P/N: 22972-005
8.625 LG
P/N: 22972-004
CHECK
GEAR DRIVE GEAR DRIVE
CHECK
HOT
BELT DRIVE CLOCKWISE
COUNTER
CLOCKWISE
LUBRICATION
LUBRICATION
LIFTING POINT LIFTING POINT
LUBRICATION
LUBRICATION
D
C
B
A
P/N: 25249-001
P/N: 22122-001
P/N: 25250-001
CONTACT PARTS
DEPARTMENT
MODEL
SERIAL NO.
P/N: 13118
KEEP FEET
CLEAR
WARNING
KEEP HANDS
CLEAR
WARNING
P/N 28853-001
RECOMMENDED MAINTENANCE
CHECK LUBRICATE CLEAN
DAILY:
OCCASIONALLY:
ENGINE OIL SPINDLE BEARINGS
AIR CLEANER
(WHEN CUTTING DRY)
BELT TENSION
HYDROSTATIC
TRANSMISSION OIL
HYDRAULIC LIFT
SYSTEM RESERVOIR
(IF SO EQUIPPED)
ALL BEARINGS
SUBFRAME PIVOT
REAR AXLE
JACK SHAFT
HANDWHEEL
(IF SO EQUIPPED)
CLEVIS PINS
ROLLER CHAINS
FRONT WHEEL BEARINGS
LIFT MECHANISM
SCREW
(IF SO EQUIPPED)
FUEL STRAINERS
FILTERS
AIR CLEANER
WATER PUMP
INLET STRAINER
COMPLETE MACHINE
23556-001
P/N 23596-001
When Larger Blade and Guard
is Installed, Belt Drive MUST
Be Changed to Proper Size.
See Owners Manual.
S.M.I. MASONRY AND CONCRETE
SAW MANUFACTURER’S INSTITUTE
CAUTION
FAILURE TO COMPLY COULD RESULT
IN SERIOUS BODILY INJURY.
P/N 23330-001
P/N 35167 P/N 35166 P/N 11092
2
P/N 29736
RO
TATION
RO
TATION
P/N 25491
P/N 25678
P/N 36099 (ISO Blue)
P/N 25867
P/N 35137
To avoid injury,
you MUST read
and understand
operator’s manual
before using this
machine.
Ask for training
as needed.
This machine to
be operated by
qualified
personnel only.
P/N 35137
WARNING