Mb25a — nameplate and decals, Nameplate and decals – Multiquip MB25A User Manual
Page 16
PAGE 16 — MB25A REBAR BENDER • OPERATION AND PARTS MANUAL — REV. #3 (11/18/08)
MB25A — NAMEPLATE AND DECALS
NAMEPLATE AND DECALS
Moving parts can crush
and cut.
Keep hands clear while
machine is operating.
Pinch Point
DANGER
ELECTRICAL
SHOCK
HAZARD
During operation of this equipment, there
exists the possibility of
,
, which can cause
or even
electrocution
electrical shock or burn
severe bodily harm
DEATH!
To avoid these hazards:
NEVER use a worn or damaged power
cord. Replace defective cords immediately.
NEVER grab or touch a live power cord
with wet hands.
NEVER let power cords lay in water.
NEVER stand in water and touch a live
power cord.
ALWAYS connect power cord to a grounded
outlet.
NEVER operate this equipment in damp or
wet conditions.
Always wear safety goggles
and a full face shield when
bending.
Eye Hazard
DO NOT lift or move
without assistance.
Lifting Hazard
Lift with one person at
each end of the machine
using lift handles.
8010780
1. Read owner’s manual
before operating.
2. Keep unauthorized and
untrained people away
from machine during operation.
3. Keep fingers away from bending
area during operating.
4. Before bending, rebar must rest fully
within bending area (between roller
and collar).
5. If rebar is too brittle or defective, it
may be broken during bending.
stand near the working
roller side of the rebar bender.
DO NOT
6.
consider the safety of others
when bending.
ALWAYS
7.
disconnect AC plug from
power source when changing
accessories, such as rollers and
collars or machine inspection.
ALWAYS
8.
wear loose clothing or
jewelry. They can be caught in
moving parts.
DO NOT
9.
operate machine under the
influence of alcohol or drugs.
NEVER
10.
operate this equipment when
not feeling well due to fatigue, illness
or taking medicine.
NEVER
11. Use only
that does not
exceed the bending capacity of the
machine.
graded rebar
SAFETY INSTRUCTIONS
1
2
6
3
4
5
MODEL
SERIALNO.
* Position the stopper (A) so that the rebar (B) to be bent is parallel to the
front of stopper
A
B
RIGHT
WRONG
B
A