Multiquip C30HDNI - Manual (Page 34)

PAGE 34 — MAYCO C-30HDNI (PRECISION) PUMP — OPERATION AND PARTS MANUAL — REV. #7 (04/03/12)
C-30HDNI (PRECISION) PUMP — INSPECTION
Figure 13. Engine Oil Dipstick (Removal)
3. Check the engine oil level as shown on the dipstick
(Figure 14).
4. If the engine oil level is low, add oil through the engine oil filler
hole (Figure 15) with the recommended oil type (Table 3).
Maximum oil capacity is 3-3/8 quarts (3.2 liters).
Figure 14. Engine Oil Dipstick
Figure 15. Engine Oil Filler Hole
Reference manufacturer engine
manual for specific servicing
instructions.
NOTE
Engine Oil Check
1. To check the engine oil level, place the pump on secure
level ground with the engine stopped.
2. Remove the dipstick from its holder (Figure 13) and wipe it
clean.
CAUTION - General Saftey Guidelines
ALWAYS wear approved eye and hearing
protection before operating the pump .
NEVER operate the pumps's engine with the
engine hood removed. The possibility exists
of
hands , long hair , and clothing
becoming entangled with the V-belt, causing
injury and bodily harm.
NEVER place hands or feet inside the hopper . ALWAYS make
while the engine is running. ALWAYS shut-down the engine
before performing any kind of maintenance service on the
pump.
NEVER operate the pump in a confined
area or enclosed area structure that does
not provide ample
free flow of air .
Before Starting
1. Read safety instructions at the beginning of
this manual.
2. Removing any dirt and dust that might have accumulated
around the engine cooling air inlet, fuel injection system.
3. Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
4. Check fuel injection system for external dirt and dust. Clean
with dry compressed air.
5. Check fastening nuts and bolts for tightness.
6. Connect Battery
7. Make sure hopper is free of dirt and foreign debris (large
objects over 2-inches)
8. Make sure radiator is filled with proper amount of anti-freeze
water solution (50/50).
9. Make sure all hose lines are in good condition and are
working properly.