Multiquip MVH206GH - Manual (Page 9)

MVH-206GH PLATE COMPACTOR • OPERATION AND PARTS MANUAL — REV. #0 (06/17/08) — PAGE 9
RULES AND REGULATIONS
LOADING AND UNLOADING
„ Before lifting, make sure that equipment parts (hook and
vibration insulator) are not damaged and screws are not
loosened or lost.
„ ALWAYS make sure crane or lifting device has been
properly secured to the lifting bail (hook) of the equipment.
„ NEVER lift the equipment while the engine is running.
„ Use adequate lifting cable (wire or rope) of sufficient
strength.
„ Use one point suspension hook and lift straight upwards.
„ NEVER allow any person or animal to stand underneath
the equipment while lifting.
„ DO NOT lift machine to unnecessary heights.
TRANSPORTING
„ ALWAYS shutdown engine before transporting.
„ Tighten fuel tank cap securely and close fuel cock to
prevent fuel from spilling.
„ ALWAYS tie down the equipment during transport by
securing the equipment with rope.
REFUELING
MAINTENANCE SAFETY
„ NEVER lubricate components or attempt service on a
running machine.
„ ALWAYS allow the machine a proper amount of time to
cool before servicing.
„ Keep the equipment in proper running condition.
„ Fix damage to the equipment immediately and always
replace broken parts.
„ Dispose of hazardous waste properly. Examples of
potentially hazardous waste are used motor oil, fuel and
fuel filters.
„ DO NOT use food or plastic containers to dispose of
hazardous waste.
„ DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
FUEL
FUEL
TYPICAL
PLATE COMPACTOR