beautypg.com

Startup – Multiquip MVC88VTHW User Manual

Page 18

background image

page 18 — MVC88VTH/VTHW pLaTe COMpaCTOR • OpeRaTiOn and paRTs ManuaL — ReV. #2 (12/09/13)

This section is intended to assist the operator with the

initial start-up of the compactor. It is extremely important

that this section be read carefully before attempting to use

the compactor in the field.

sTaRTing THe engine

1. Place the engine fuel valve lever (Figure 12) to the

On” position.

Figure 12. Engine Fuel Valve Lever (ON Position)

2. Move the throttle lever (Figure 13) away from the

idle

position, about 1/3 of the way toward the

run position.

Figure 13. Throttle Lever (1/3 Start Position)

CauTiOn

dO nOT attempt to operate the compactor

until the Safety, General Information and

Inspection sections of this manual have

been

read and thoroughly understood.

STARTUp

3. Place the

choke lever (Figure 14) in the “CLOsed”

position if starting a cold engine.

Figure 14. Choke Lever (Closed)

4. Place the engine ON/OFF switch (Figure 15) in the

"

On" position.

Figure 15. Engine ON/OFF Switch (ON Position)

5. Grasp the starter grip (Figure 16) and slowly pull it

out. The resistance becomes the hardest at a certain

position, corresponding the compression point. Rewind

the rope a little from that point and pull out sharply.

CLOSED

CHOKE LEVER

NOTICE

The

CLOsed position of the choke lever enriches the

fuel mixture for starting a

COLd engine. The Open

position provides the correct fuel mixture for normal

operation after starting, and for restarting a warm

engine.

This manual is related to the following products: