Purenex Multipure Aquaversa - Manual (Page 15)

Attach the Adapters to the Housing
1. Connect the included Inlet adapter (MC720) to the system housing’s labeled Inlet port.
rotate the adapter clockwise, first by hand, then using a wrench, to tighten onto the
system.
2. Connect the included Outlet adapter (MC720) to the system housing’s labeled Outlet
port. rotate the adapter clockwise, first by hand, then using a wrench, to tighten onto
the system.
1. using wire cutters or a knife, cut (square cut) the tip end off of the blue plastic tubing
(either connected to the faucet or a separate piece included with the Capacity Monitor).
Do not use scissors.
2. Fully insert the tubing into the adapter on the OuTleT port of the system housing; the
tubing should typically be inserted 5/8” into the adapter.
nOTe: when pushing the tubing into the adapter, you will encounter some resistance.
This does not mean that the tube is fully inserted. Continue to push firmly until the tubing
is inserted as far as possible (roughly 5/8” into the adapter).
3. Pull on the tubing to make sure that it is securely connected.
Housing Top
Insert tubing and push until you
feel resistance -- at this point,
the tubing is not fully inserted.
Push firmly until the tubing is
inserted as far as it will go.
15
3.4: Connecting the Tubing to the Housing
Connect the Tubing to the Outlet Port
blue tubing
OuTleT
Adapter
OuTleT
InleT
Connect the Tubing to the Inlet Port
1. using wire cutters or a knife, cut (square cut) the tip end off of the clear plastic tubing con
nected to the Adapta Valve. Do not use scissors. Do not cut more than 1/2" off of the
end of the clear plastic tubing.
2. Fully insert the tubing into the adapter on the InleT port of the system housing; the
tubing should typically be inserted 5/8” into the adapter.
nOTe: when pushing the tubing into the adapter, you will encounter some resistance.
This does not mean that the tube is fully inserted. Continue to push firmly until the tubing
is inserted as far as possible (roughly 5/8” into the adapter).
3. Pull on the tubing to make sure that it is securely connected.
clear tubing
InleT
adapter
Connecting to straight Adapter
Insert tubing and
push until you feel
resistance -- at this
point, the tubing is
not fully inserted.
Push firmly until the
tubing is inserted as
far as it will go.
Insert blue tubing 5/8”