MTS Criterion Series 40 - Manual (Page 41)

Moving C43 (30 kN, 50 kN) and C44 Frames
MTS Criterion
®
Series 40 Site Preparation Guide
Lift and Move Instructions 41
To transport the load frame using the crosshead method:
1. Ensure that there are no shipping bolts attached to the skid.
2. Using a forklift with padded forks or protective material around the
crosshead, carefully insert the forks under the crosshead between the
columns.
The frame may overturn suddenly when lifting the frame.
An overturned frame can cause injury or death to anyone in the immediate
area.
Ensure that all persons in the immediate area are standing away from the frame
during lifting. Do not lift the frame more than 8 cm (3 in) off the floor.
3. Slowly and carefully lift the frame off the floor.
4. Remove the shipping skid, if it has not already been removed.
5. Move the frame to its operating location.
6. Four leveling feet are supplied for the load frame. Thread one leveling foot
into each corner of the base before placing the frame in its testing location.
7. Place the load frame carefully into position.
8. Remove the padded forks from under the frame’s crosshead.
When the frame is in the testing location, you can proceed with the installation
process.
WARNING
Forklift Arm
Crosshead
Protective Material
Leveling Foot
Lifting the Frame from the Crosshead