MK Diamond MK-20 Series - Manual (Page 23)

23
MK-20 SERIES CLEANUP
(J)
Install the Blade Shaft Cover.
(L)
Install the Pointer on the opposite
side, next to Blade Guard.
(See Front Pointer alignment Page
16)
(K)
Remove the Pointer.
EMERGENCY ENGINE SHUTDOWN
(A)
Place Engine Master Switch in the
OFF position.
(B)
Move the Throttle Lever to lower
blade speed. Place Fuel Valve in
the OFF position.
CLEANUP
Engine parts are extremely hot following use, allow engine to cool 1/2-hour before
cleaning. Use care during cleanup to avoid injury.
CAUTION
1. To extend operating life, the Concrete Saw should be cleaned following
every use.
2. Using a garden hose or pressure washer is not advised as it can force water
into the air cleaner or muffler opening. Steam cleaning is the preferred
method of cleaning.
3. Use care when cleaning around electrical components.
NOTE: