MK Diamond MK-2000 Electric - Manual (Page 17)

17
Your MK-2000 Electric Saw has been shipped from the factory thoroughly inspected. Only minimal as-
sembly is required.
Use proper lifting techniques when lifting the MK-2000 Electric Saw.
CONTENTS
In your container, you will find one (1) MK-2000 Electric Saw and water basin, one (1) diamond blade,
one (1) MK-2000 Electric Saw movable cutting table, one (1) adjustable cutting guide, one (1) electric
water pump, one (1) pump discharge fitting, one (1) cooling transfer tube, one (1) drain plug, one (1)
blade wrench, one (1) owners manual, one (1) pump manual and one (1) warranty card.
www.mkdiamond.com
MK Diamond Products, Inc.
Caution: Read all safety and operating instructions before
using this equipment. This owners manual MUST accompany the equipment at all times.
MK-2000 SERIES MASONRY SAW OWNERS MANUAL & OPERATING INSTRUCTION
06.2009 Revision 100 Manual Part No. 156402
MK-2000 Frame
Pump
Manual
Warranty
Card
Cooling
Transfer Tube
Drain Plug Wrench Owner’s
Manual
Pump
Discharge Fitting
Electric
Water Pump
Adjustable
Cutting Guide
Movable
Cutting Table
Diamond Blade
To transport:
• Verify the Movable Cutting Head is locked in the down position and the Movable Cutting Table
is removed
• Grasp the saw by the recessed handle in the right and left upright castings
• Grasp the front of the saw
• Lift and transport the saw to the desired work location
MK-2000 ELECTRIC SAW UNPACKING, CONTENTS, AND TRANSPORT
Remove Movable
Cutting Table
Fork Lift Point
Cutting Head
Locked Down
Fork Lift Point
CAUTION
CAUTION
TRANSPORT
Lock the Cutting Head in the “DOWN” position and remove the Movable Cutting
Table when transporting the MK-2000 Gas Saw.
Recessed Handle
UNPACKING
Never transport the MK-2000 Electric Saw with water in the Water Basin.
The MK-2000 Electric Saw is designed with recessed handles in the right and left
upright castings or forklift brackets on the bottom for ease of transport.
NOTE: