MK Diamond MK-2000 Electric - Manual (Page 14)

14
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
5 H.P.
25’
50’
75’
100’
150’
250’
230v
50’
100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length
No. 12 Wire
No. 10 Wire
No. 8 Wire
No. 12 Wire
No. 10 Wire
No. 8 Wire
No. 6 Wire
115v 230v
NOTICE !
The MK-2000 Electric Saws is equipped with a number of safety decals provided for operator safety
and maintenance information. Should any of these decals become unreadable, replacements can be
obtained by calling (800) 262-1575.
Masonry Safety Decal Sheet, Part No. 166011
OPERATION & SAFETY DECALS
Decal G
MK-2000 ELECTRIC SAW SAFETY
Decal D Decal E
Decal C
Decal F
Decal A
Decal B
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica
in their composition may give off dust or mists containing crystalline silica. Silica is
a basic component of sand, quartz, brick clay, granite and numerous other minerals
and rocks. Repeated and/or substantial inhalation of airborne crystalline silica
can cause serious or fatal respiratory diseases, including silicosis. In addition,
California and some other authorities have listed respirable crystalline silica as a
substance known to cause cancer.
!
CAUTION
DO NOT
operate with-
out guards in
place.
!
WARNING
In the event of blade
failure, replace blade
guard immediately.
! DO NOT operate
this equipment
before reading the
owners’ manual!
WARNING !
CAUTION
DO NOT
operate with-
out guards in
place.
!
Receptacle is for
water pump only.
125V, .6 amps max.
! CAUTION
This saw is to be used
with a Ground Fault
Circuit Interrupter.
! CAUTION
Decal H Decal I
Decal J
For manuals and parts
lists scan the QR code
with your smart phone