MK Diamond MK-101-24 - Manual (Page 33)

33
(J)
Lubricate the Cutting Head
Adjustment Knob.
(K)
Lubricate the Cutting Head
Adjustment Knob retaining
holes.
(L)
Lubricate the Cutting Head
Pivot Shaft.
If flow to the diamond blade requires adjustment, perform the following actions.
(A)
Increase cooling flow by releas-
ing the Flow Adjusting Clamp.
(B)
Reduce cooling flow by
Pressing down on the Flow
Adjusting Clamp.
Flow Adjustment
MK-101-24 MAINTENANCE
NOTE:
Like most cutting instruments, a diamond blade performs best when it is dressed. Over time and use,
diamonds on the outer edge of the blade will become smoothed or "glazed" over. This will reduce
grinding efficiency and may cause the blade to "wander" or bend giving the illusion of an alignment
problem. When this occurs, the blade will need to be dressed. The diamond blade can be dressed
using the MK Dressing Stick (MK Diamond Part No 152792) and by following the steps below.
Blade Dressing
(A)
Setup the MK100 for operation
(See Setup, Adjustment
and Operation).
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip.
(C)
Position the Dressing Stick. Cut
2 or 3 strips from the dressing
stick to dress the Blade.