MK Diamond MK-101-24 User Manual

Page 19

(A)

Position Movable Cutting Table

to the front of the saw.

(B)

Raise the Blade Guard by

loosening the wingnut.

(C)

Locate the Shaft Lock push

button on the underside

of the Cutting Head.

(D)

Depress and hold the Shaft

Lock pushbutton and remove

Retaining Nut and Outer Flange

using the Blade Wrench.

(E)

Install Diamond Blade

onto Blade Shaft.

(F)

Verify the Blade is seated on

the Blade Shaft and direction

of rotation is correct.

(G)

Install Retaining Nut and Outer

Flange, depress and hold the

Shaft Lock pushbutton

and tighten Retaining Nut.

NOTE: When installing the Retaining Nut, do not “cross-thread” and DO NOT over tighten.

Diamond Blade Installation

MK-101-24

ASSEMBLY